Innotox 100UI
Botulinum toxin type A · 100 units in 2.5 mL · ready-to-use liquid. Manufactured by Medytox, South Korea.
$74.90
You save
- Innotox 100UI holds double the volume of the standard vial, ready to inject straight from the bottle with no dilution. It suits larger areas or multi-zone sessions, sharing the same HSA-free formula and 10-month duration as the 50UI version.
Professional use only. This product is intended for administration by licensed healthcare practitioners trained in the relevant anatomy and injection technique. By ordering you confirm you are authorised to purchase and handle products of this class in your jurisdiction. Availability and permitted use vary by country — please verify local regulations before ordering.
In accordance with applicable U.S. FDA regulations, this product is not available for purchase or shipment to U.S. addresses through this website. Customers in the United States should obtain botulinum toxin products through appropriately licensed and authorized U.S. distribution channels. A valid medical license or registration certificate is required to process any product-related claim.
Did you like this product? Add to favorites now and follow the product.
(+82) 10 7364 7998 Send a message on WhatsApp.
A ready-to-use liquid toxin — no reconstitution, no albumin
Innotox is the liquid botulinum toxin type A made by Medytox in South Korea. It differs from almost every other toxin in this category in two ways that matter day to day in a clinic.
It arrives pre-mixed. The 100-unit vial contains 2.5 mL of solution at 4 units per 0.1 mL, drawn straight from the vial. There is no freeze-dried cake, no saline to source, no reconstitution step and no dilution arithmetic — which removes the single most common source of preparation error and saves a few minutes per treatment.
It is formulated without human serum albumin. Where conventional toxins use albumin — a human blood derivative — as the stabiliser, Innotox uses non-animal-derived stabilisers instead. For practices whose patients ask about blood-derived excipients, that is a straightforward answer rather than a caveat.
The trade-off is that a pre-mixed liquid cannot be prepared at a concentration of your choosing. If your technique depends on varying dilution by treatment area, a lyophilised product gives you that control and Innotox does not.
Supplied as a solution and drawn directly from the vial. No saline to source, no mixing step, no dilution arithmetic.
Stabilised without human serum albumin, using non-animal-derived excipients instead.
Removing the preparation step saves a few minutes per treatment and removes a common source of error.
4 units per 0.1 mL as supplied. Dose is varied by volume injected rather than by dilution.
Why practitioners choose Innotox 100UI
Arrives as a solution at 4 units per 0.1 mL. No reconstitution means no diluent to buy, no mixing step and no risk of a dilution error.
Uses non-animal-derived stabilisers rather than human serum albumin, which answers a question some patients ask directly.
Because the manufacturer sets the concentration, every vial is identical — there is no variation introduced at the bench.
50 U and 100 U share the same formulation and concentration, so smaller lists do not require opening a larger vial.
Aesthetic & therapeutic applications
Areas commonly treated with this product. Because Innotox is supplied at a fixed 4 units per 0.1 mL, dose is adjusted by the volume injected rather than by preparing a different concentration for each area. Approval status differs between markets — always work from the prescribing information registered where you practise.
Lines produced by corrugator and procerus activity. A ready-to-use solution removes the reconstitution step here, which matters most on a single-area appointment where preparation is a large share of the visit rather than a small one.
Lines at the outer eye produced by orbicularis oculi activity. Widely treated in aesthetic practice; whether it is an approved indication for this product depends on your market.
Horizontal forehead lines from frontalis activity. At the fixed 4 units per 0.1 mL, light forehead dosing is delivered as small volumes — 0.025 mL per point gives 1 unit — so a fine-gauge syringe with clear graduations is worth having. A practitioner decision within local regulations.
The fixed concentration suits practitioners who vary dose by volume rather than by dilution. If your technique relies on preparing a more dilute solution for delicate areas, a lyophilised product gives you that control and this one does not.
Botulinum toxin products are prescription-only medicines. Any use outside the indications approved in your jurisdiction is a clinical decision made by the treating practitioner under their own professional judgement and local regulatory framework. Korea Filler Experts supplies the product; nothing here should be read as a recommendation to treat any medical condition.
What is inside Innotox 100UI
| Active substance | Clostridium botulinum toxin type A |
| Strength | 100 Units per vial |
| Volume | 2.5 mL |
| Concentration as supplied | 4 Units per 0.1 mL |
| Pharmaceutical form | Solution for injection — ready to use, not reconstituted |
| Stabilisers | Non-animal-derived; contains no human serum albumin |
| Container | Single-use vial |
| Route | Intramuscular injection |
| Manufacturer | Medytox Inc, South Korea |
| Regulatory class | Prescription-only medicine (professional use) |
Reading the carton
Before you accept a delivery, check four things:
- The lot / batch number on the carton matches the number printed on the vial.
- The expiry date leaves you enough working life — we do not dispatch stock with under 6 months remaining unless agreed in advance.
- The seal is intact and the vial has not been disturbed.
- The carton arrived cold, with the coolant pack still chilled. This matters more for a liquid product than for a powder.
The solution should be clear. Unlike a lyophilised toxin, you can inspect this product before use. Do not use it if the solution is cloudy, discoloured or contains visible particles.
What makes this formulation different
- Liquid, not lyophilised — supplied as a solution rather than a freeze-dried cake, so it is drawn and injected without preparation.
- No human serum albumin — conventional toxins use albumin, a human blood derivative, as the stabiliser. Innotox does not.
- Manufacturer-set concentration — 4 units per 0.1 mL in every vial, so dose is adjusted by volume injected rather than by dilution.
How it works
After intramuscular injection, botulinum toxin type A binds to receptors on presynaptic cholinergic nerve terminals and reduces the release of acetylcholine, the neurotransmitter that triggers muscle contraction. Activity in the injected muscle falls, and the movement producing a dynamic line decreases with it.
The effect is temporary. Nerve terminal function recovers over time, which is why treatment is repeated rather than permanent.
How to use Innotox 100UI
Innotox is supplied ready to use. There is no reconstitution step, and no diluent should be added. Reference information for licensed practitioners — administration must follow the prescribing information approved in your market.
Step by step
-
Inspect the solution
Check the lot number and expiry date, and confirm the seal is intact. The solution should be clear and free of particles. Do not use a vial that is cloudy or discoloured.
-
Bring to working temperature
Take the vial from refrigerated storage shortly before use. Do not warm it artificially.
-
Disinfect the stopper
Wipe the exposed rubber stopper with an alcohol swab and allow it to dry.
-
Draw directly
Draw the required volume straight from the vial with a sterile syringe and a fine-gauge needle. Do not add saline or any other diluent.
-
Inject without delay
Draw immediately before injection rather than preparing syringes in advance.
-
Store and discard correctly
Return any remaining product to 2–8 °C and use within the period stated in your approved prescribing information. Single-patient use only.
Administration notes
Do not reconstitute this product. It is supplied as a solution at 4 units per 0.1 mL and adding diluent would change the concentration your dosing assumes.
- Dose is adjusted by the volume injected, not by dilution. At 4 U per 0.1 mL, 0.05 mL delivers 2 units.
- Units of botulinum toxin are product-specific. Do not convert or substitute units between brands.
- Dose per site, total dose and injection technique must follow the prescribing information approved in your market.
- Treatment intervals should not be shortened below the minimum stated in the prescribing information.
After treatment
- Avoid rubbing or massaging the treated area for at least 24 hours
- Stay upright and avoid lying down for 4 to 6 hours
- Avoid strenuous exercise for 24 to 48 hours
- Avoid saunas, hot tubs and excessive sun exposure for at least 24 hours
- Mild redness, swelling or bruising can occur and usually settles within a few days
Storing and handling Innotox 100UI
Store refrigerated at 2–8 °C in the original carton, protected from light. Do not freeze. Freezing is a particular risk for a liquid product — a frozen and thawed vial must not be used.
Keep at 2–8 °C and use within the period stated in your approved prescribing information. Single-patient use only. Do not pool vials.
Transfer stock into a monitored medical refrigerator on arrival and keep a temperature log. A liquid formulation has less tolerance for temperature excursion than a freeze-dried one, so check the coolant packs on delivery.
Do not use the vial if the solution is cloudy, discoloured or contains particles, if the expiry date has passed, or if the cold chain is known to have been broken. Because this product is supplied as a liquid, a visual check before every use is both possible and worth doing. Dispose of unused product and used vials as clinical waste in line with local requirements.
What's included with Innotox 100UI
No diluent is required or supplied — this product is ready to use. Syringes and needles are not included and must be sourced separately.
Innotox 100UI — frequently asked questions
What is Innotox 100UI?
Innotox 100UI is a liquid botulinum toxin type A manufactured by Medytox in South Korea. It is supplied as 2.5 mL of ready-to-use solution at 4 units per 0.1 mL, drawn directly from the vial by a licensed practitioner. Unlike most toxins it is not freeze-dried and is not reconstituted.
Do I need to reconstitute it?
No, and you should not. Innotox arrives as a solution at a concentration set by the manufacturer. Adding saline would change the concentration your dosing assumes. Draw the required volume straight from the vial.
How do I work out the dose without a dilution table?
Dose is adjusted by volume rather than by dilution. At 4 units per 0.1 mL, 0.05 mL delivers 2 units, 0.1 mL delivers 4 units, 0.25 mL delivers 10 units, and the full 2.5 mL vial delivers 100 units.
What does "albumin-free" mean, and why does it matter?
Most botulinum toxins use human serum albumin — a protein derived from human blood — to stabilise the toxin. Innotox is formulated with non-animal-derived stabilisers instead.
In practice this matters most as an answer to a patient question. Some patients ask specifically about blood-derived components, and with this product the answer is simply that there are none.
Is a liquid toxin as stable as a freeze-dried one?
A liquid formulation has less tolerance for temperature excursion than a freeze-dried powder, which is why the cold chain matters more here. Store at 2–8 °C, never freeze, and check coolant packs on arrival. The upside is that you can visually inspect the solution before every use, which is not possible with a powder.
When might I prefer a lyophilised toxin instead?
If your technique depends on varying the concentration by treatment area — a more dilute preparation for fine superficial work, a more concentrated one elsewhere — a lyophilised product lets you set that at the bench and Innotox does not. The concentration here is fixed at 4 units per 0.1 mL.
Should I order the 50 U or the 100 U vial?
Both share the same formulation and the same 4 units per 0.1 mL concentration. The 50 U vial suits shorter treatment lists; since reconstituted or opened product is single-patient use, sizing the vial to the session rather than the week avoids waste.
Can I substitute Innotox units for another brand's units?
No. Units of botulinum toxin are specific to each product and are not interchangeable between brands. Dosing must be taken from the prescribing information for the product in your hand.
What shelf life will my stock have?
We do not dispatch stock with less than six months of remaining shelf life unless you have specifically agreed to it. If you need a particular expiry window, tell us before you order and we will allocate accordingly.
What happens if my shipment arrives warm?
Do not use it. Photograph the outer box, the insulated liner, the coolant packs and the vial carton, and contact us the same day with your order number. We will review the cold-chain evidence and arrange a replacement where the failure occurred in transit.
Who is allowed to buy this product?
Botulinum toxin is a prescription-only medicine. Purchase and use are restricted to licensed healthcare professionals qualified to prescribe or administer injectable prescription medicines in their jurisdiction, with appropriate training in the relevant anatomy and injection technique. We do not sell to consumers.
Customer Reviews
Share your experience with this product. Your honest review helps other customers make better choices.
- Sort By
- Newest
- Oldest
- Highest Rating
- Lowest Rating
⭐⭐⭐⭐⭐ Absolutely Love Innotox!
I absolutely love Innotox! The results have been amazing, leaving me with a smoother, more refreshed and youthful appearance while still looking natural. I love how it softens the appearance of fine lines and wrinkles without making my face look frozen. I’m extremely happy with my experience and the results. Definitely one of my favourites! Highly recommend! ❤️
Great product and better communication. Will purchase from them again.
Copyright 2026 © Korea Filler Experts. All right reserved.
